Connect-Tek Transa PRO 17 Manual de Instruções Página 7

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 6
3
1–3 Programming Port and DIP Switch
Front
Panel
Rear
Terminal
Figure 1. Access Hole
Overview
.
Table 1.1 DIP Switch
Configuration
TC, RT D , mV
0-1V, 0-5V, 1-5V, 0-10V
0-20 mA, 4-20 mA
Input 1
Select
All parameters are Unlocked
Only SP1, SEL1 SEL5 are unlocked
Only SP 1 is unlocked
All P a ramete rs are locke d
Lockout
12
34
DIP Switch
:ON :OFF
Factory Default Setting
*
Access Hole
1
ON DI P
2 3 4
The programming port is used to connect to
the TEC99001 for instant programming
from a computer
The programming port
is used for off-line auto-
matic setup and testing
procedures only. Do not
attempt to make any con-
nection to these pins
when the unit is being
used for normal control
purposes.
When the unit leaves
the factory, the DIP
switch is set so that TC
and RTD are selected for
input 1 and all parameters
are unlocked, unless
another configuration is
requested.
Lockout function is
used to disable the adjust-
ment of parameters as
well as operation of cali-
bration mode. However,
the menu can still be
viewed even under lock-
out condition.
*SEL1-SEL5 represent
those parameters which
are selected by using
SEL1, SEL2,… SEL5
parameters contained in
the setup menu. The
parameters that have
been selected are then
allocated at the begin-
ning of the user menu.
Vista de página 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 91 92

Comentários a estes Manuais

Sem comentários