Connect-Tek Transa PRO 17 Manual de Instruções descarregar pdf (Página 57)

5–10 RS-485

A tile making plant has five production

lines. Each production line is equipped

with 16 TEC-9300 units to control the

temperature for the kiln. They want to

program the controllers and monitor the

process from the control room to improve

quality and productivity. A cost-effective

solution for the above application would

be to use 80 TEC-9300 units plus an

SNA10B smart network adapter and BC-

Net PC-based software for this purpose.

The system is installed as shown in the

following diagram.

Setup

Enter setup mode to configure each TEC-

9300. Choose FULL for FUNC, 485 for

COMM, RTU for PROT, and select a dif-

ferent address (ADDR) for each unit. Use

the same values of BAUD, DATA, PARI,

and STOP for the TEC-9300’s, SNA10B

and BC-Net. Also refer to section 2-15

and section 4-8.

Taking advantage of BC-Net software, the

operator can monitor the process on the

PC screen, program the set point as well as

other control parameters such as PID val-

ues, download the ramp and soak profile

to the controllers, execute the manual con-

trol or trigger auto-tuning, etc., and print

out reports as required. The historical data

can be saved in the floppy drive, hard

drive, or on a CD for permanent storage.

Setup menu

FUNC

COMM

PROT

ADDR

BAUD

DATA

PARI

STOP

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 91 92

Sem comentários

Connect-Tek Transa PRO 17 Manual de Instruções Página 57