Connect-Tek Transa PRO 17 Manual de Instruções descarregar pdf (Página 111)

5.1.3.7. nits (section 4.2.2.6.2)

5.1

od low frequency is not part of the normal operating

condition of this application, set the min. frequency as high as possible to

aid the tachometer in determining zero speed (stopped) condition sooner.

t 1 p

Enter units as “rpm”

.3.8. Input Type (section 4.2.2.6.3)

Select Frequency.

.3.9. Min Freq(section 4.2.2.6.4)

Since it understo

Min frequency = 100 Hz

Relay Outpu Setu

)

utp . Select Input A for source.

ction 4.2.4.2.1)

Select Off

Digital 1 &2, Relay 2 and Analog Output

5.1.3.10. Source (section 4.2.4.1

Navigate back to Relay O ut 1 setup

5.1.3.11. Latch Mode (se

5.1.3.12. On / Off Delay (section 4.2.4.2.2)

No delay is desired. Enter 0.00 for both.

5.1.3.13. Output Switching (section 4.2.4.4.2)

Relay 1 is being used to ensure that speed does not drop below 1900 rp

• Select EB (energize below)

• Enter +1.900e+3 for the Alarm setpoint

• Enter +1.980e+3 for the Safe setpoint.

None of these functions are being used and Source for each should be set to None.

Security Setup

No displays are in use. Therefore security is set on TACHLINK only.

5.1.3.14. Alarm Hold-Off (section 4.2.6.2)

ode using 1 through 4 keys.

Set to Off.

.1.3.15. Keyboard Lock (section 4.2.6.3)

Set to Locked

.1.3.16. Change Security Code (section 4.2.6.5)

Set the 8-digit security c

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 132 133

Sem comentários

Connect-Tek Transa PRO 17 Manual de Instruções Página 111